Harmony 890 z-wave setup

On August 7, at , kluskey said Before you can reply to a message You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Register for an account. Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. For information on how to advertise your service or product click here.

Remote Central reserves the right to remove or modify any post that is deemed inappropriate. The following page was printed from RemoteCentral. Register Forum Search Login. Harmony as a Z-Wave lighting controller This thread has 8 replies. Displaying all posts. Post 1 made on Sunday August 5, at Joined: Posts:. August 1. Post 2 made on Monday August 6, at December As unbelievable as it is, the harmony software does not have a feature to select a scene at the end of an activity.

It has been over 3 months since I asked this and they have not yet delivered it. The following is taken from the official FAQ about scenes: "Note: It is not possible to map a scene to the end of an activity or when you press the OFF button. This says a lot about the poor quality of software development for these remote controls. Does anyone at Logitech actually use the software that they produce on a daily basis? Post 3 made on Tuesday August 7, at January 4.

If so, move on to step Create any Scenes — since you still have to update the remotes, which is the most painful part of the process, you might as well create any scenes you need.

When finished, click done. If you only have one HP, you are finished. Vera can still control your lights. Again, the dongle will blink rapidly, and again, the HP will tell you that it is now the primary controller. When finished, plug dongle back into Vera. Then go into the z-wave device settings and select No under Automatically Configure. Then click save, and you are finished. Jump to: navigation , search. From this point on, the Pro will just exist and work with the existing nodes, any other nodes would need to be added to the Pro and the process in ThinkEssentials would have to start over Add Vera as a secondary controller Update Vera from ThinkEssentials, all nodes will be available in Vera, Vera will be a Secondary Controller.

Add Nodes to Vera — as you normally would. Repeat Steps above 4. Repeat Steps above. Categories : Hardware User Instructions. Personal tools Log in. Namespaces Page Discussion. Views Read View source View history.

This page was last modified on 15 April , at This page has been accessed 38, times. You can use the Harmony mobile app to do this. Finally, place your device into exclusion mode. If your device takes more than 15 seconds, you may need to repeat the process. Harmony will notify you once your plug has been excluded.

It will now be ready to re-pair with Harmony. If so, you can use the Harmony mobile app to do so. We need to know which type of remote you have in order to provide you the correct instructions.